V2C Electric Chargers
V2C » Support Area » Power control » Dynamic » Photovoltaic » Integration of the Enphase microinverter with Trydan

Integration of the Enphase microinverter with Trydan

The Enphase microinverter can be integrated with the e-Charger Trydan via a WiFi connection. Below, we specify the steps to follow to carry out this integration. (These steps must be done on the Master microinverter).

IMPORTANT: Integration with Enphase is currently in development.

The use of Wi-Fi repeaters or mesh networks may affect the proper functioning of the system. We recommend using a stable and direct Wi-Fi network to ensure an optimal connection between the charger and the inverter.

Steps for connecting to the Enphase microinverter

Enter the following URL in your browser: https://enlighten.enphaseenergy.com/. Then, log in with your email and password.

Go to the ‘System Board’ section, located at the top right.

Copy the serial number from the Gateway section (SERIAL NO).

Open a new web tab and enter the following URL: https://enlighten.enphaseenergy.com/entrez-auth-token?serial_num=ID. Then, in the URL, replace ‘ID’ with the serial number you obtained in the previous step

Copy all the content after ‘token’ without selecting the quotation marks.

Send this information (along with the charger’s ID number) to the Support team: [email protected].

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5

Are you in need of technical assistance?

Simply submit a request through our Technical Support Center, and we’ll promptly reach out to provide you with the optimal solution.

Contact Technical Support