How to replace the standard charging cable with a Tesla button cable
This guide explains step by step how to replace the standard charging cable of your charger Trydan with a Tesla button cable.
Below, you will find the detailed procedure, the prior recommendations, and the necessary final checks to safely carry out the change and ensure the proper functioning of the equipment.
Warning! The cable must only be replaced by qualified technical personnel with knowledge of electrical installations and electric vehicle chargers. Tampering with the charger without proper training may cause damage to the equipment, serious electrical hazards and loss of warranty. V2C declines all responsibility for rights arising from such non-compliance.
Steps to replace the charging cable
Standard cable extraction
First of all, it is mandatory to turn off the equipment to perform the work safely. Once the absence of voltage has been verified, you must remove the three existing terminals (L, N, and TT) with the help of a suitable screwdriver, as well as the signal wire (CP) corresponding to the standard charging cable of the equipment.
TT
N
L
CP
Installation of the new charging cable with Tesla button
To install the Tesla button charging cable on the device, first you must insert the wires through the strain relief into the interior of the charger. Once the strain relief is tightened, connect the five wires (L, N, TT, CP, and P3+) to the power board, following the corresponding wiring diagram.
TT
N
L
CP
P3 +
Checking the new charging cable with Tesla button
Once the connections of the three power terminals, the two signal wires, and the correct adjustment of the outer cable gland have been verified, turn on the equipment and perform a calibration.
Need technical support?
Resolve your issue instantly through our AI Chat. If it’s not resolved, generate a request in the Technical Support Center and we will contact you as soon as possible to provide you with the best solution.
