Remote Control Connection Manual
One way to lock and unlock the e-Charger is through a remote control. Below are the steps to enable remote control, allowing you to control the charger conveniently and manage charging remotely.
Steps for Connecting and Installing the Remote Control
1. Access the Power Board
Access the interior of the charger and locate the P3 and P4 ports on the power board. If either of them has a jumper installed, you need to remove it to connect the cables.
Board A
Board B
Power Board
Ports P3 and P4. Each port has two pins.
2. Connect the Remote Board
Next, connect the remote board (receiver module) to the Trydan power board. The receiver module consists of five ports: NC, COM, NO, +VCC, -GND. Secure the connection following the schematic below:
Board A
Board B
Receiver module back side
3. Configure the Remote Control
To pair a remote control:
- Press the white button located in the bottom corner of the reception module (inside the protective box) three times.
- A red light will turn on, indicating that the module is in ‘pairing mode.’
- On the remote control, press the following sequence: UNLOCK – LOCK – UNLOCK.
- The charger will turn on. To turn it off, press the LOCK button on the remote control.
- If you wish to add another remote control, repeat step 1.
To delete all remotes or reset the module:
- Press the white button in the bottom corner of the reception module 8 times.
- The red light will blink; wait for it to turn off to complete the reset process.
Receiver module front side
Programming LED Light
Programming Button
Connection Remote
NOTE: If you encounter issues with pairing, check the connection and reset the module.
Do you need technical support?
Resolve your issue instantly through our AI Chat. If it is not resolved, submit a request via the Technical Support Centre and we will contact you as soon as possible to provide the best solution.
